[rtg] Strange problem with 0.7.4

[andrew2 at one.net]

Hopefully someone can shed some light on this for me...

I've been using RTG 0.7.4 for quite some time no with no problems to
speak of.  I've been collecting data from a number of different (mostly
Cisco) network devices, but I've recently added a few 2950/2960 switches
into the network, and the strangest thing is happening.

Inbound traffic seems fine, but the data for the outbound traffic is
*identical* for every port in both of the new switches.  It would almost
make sense if it were the same for every port in one of the switches,
but it is exactly the same in both switches.  I only noticed because the
outbound graphs looked eerily similar so I decided to check a little
closer.

Looking at targets.cfg, I don't see anything really different.  Here's a
"working" 2924:

10.10.10.10     .1.3.6.1.2.1.2.2.1.16.14        32      snmpcomm
ifOutOctets_2   21      3600000000      antenna (FastEthernet0/13)

and here's from one of the problem 2950's:

10.10.10.11 .1.3.6.1.2.1.2.2.1.16.10006     32      snmpcomm
ifOutOctets_11  128     36000000000     promach (FastEthernet0/6)

Now, other than the different OID, which I'm guessing is just due to a
new MIB from Cisco since the 2924's were new, they look identical.

Has anyone seen anything like this?

Thanks,

Andrew